How to make a crocodile watch strap?
As for the question of why the crocodile skin is expensive, rare and kind, I have already elaborated in my diary. I am going to make an appointment with the factory master today. Let's share the production of the crocodile leather strap. Through the process of making it, you can distinguish the pros and cons of the product and the quality of the work when choosing the crocodile leather strap!
Material: Pure American imported crocodile skin (original origin}
French calfskin (for lining)
Imported thick line (for sewing)
Imported paper (for pattern)
Production Tools: Cut Axe (for material use)
Vernier caliper (measuring the thickness of the skin and the width of the column, etc.)
Steel ruler (quantity length width, etc.)
Knife
Needle thread (for needle hole)
Hand stitch
Start by step by step and show sharing!
Detailed production steps
1. Remove the strap and prepare the relevant measurement record data tool
2. Start measurement This is ready to measure Oil meter caliper measurement Triangle board ready to draw
3. The measurement is completed. The data is recorded on the paper jam. Then use the paper jam to make the pattern!
4. Based on the recorded data, sketch first
5. According to the drawing, the thread is cut out with a knife, which is the pattern, and the bottom is opened according to the pattern!
6. According to the drawing, cut the paper with a knife according to the stitch, and open the bottom skin according to the pattern! Pay attention to this detail. In order to ensure the perfect high-end and luxury of the product, the external crocodile skin lines of the two straps must be exactly the same, which requires careful selection by the masters.
7. According to the pattern, then use the vegetable tanned to fill the middle protruding position, the middle should be peeled and then peeled, then the vegetable tanned and painted, so that there is a convex effect outside.
8. Use the steel needle with the thickness of the column to pass through the position of the position, it must be attached to the position line, then apply glue along the line, then close the steel needle back. This process is a bit fine, if it is tight, the table After the column is installed, it is not flexible, and the glue is over-coated. When it is on the column, it will be very difficult. After folding back, attach the bottom skin and then use the tool to stick along the raised position, then correct the paper with the tool.
9. Use the needle thread to smash the needle and thread the needle
Then the watch strap is completed.
