Before the belt is removed, measure roughly how many gauge tapes are removed before it is appropriate:
1. temporarily remove the ring strap from the buckle so that the strap can be spread on the table. In order to facilitate the next action. It is better to put a pile cloth under it to protect the watch
2. after the strap is spread flat, use a pointed tool (I use small scissors) to find the position of the pin along the arrow on the back of the strap, and push it outward against the small round bulge, push the bolt outward according to the direction of the arrow.
3. after removing the appropriate length of the strap, the strap can be installed back. The pin may be a little tight, look for something that is soft and hard (I'm holding a plastic lighter) and tap it a few times, or push hard to replace it. Remember to put the buckle on.
Note that the strap of watch must be determined first that the belt particles of the watch are not connected by screws but are loaded by pins or cotter pins (also called expanding ears)
Use method of stripper: put the love meter strap in the groove of the stripper, and turn the handle clockwise with the removal hole on the side of the strap. See the following for details. Because the strip removal needle is a vulnerable part, please keep the needle and the strap pin vertical, otherwise it is easy to break. Purchase price: 3 yuan / piece
Note:
1. Most detachable band has arrow marks on the back of the strap, which can push the pin of the strap along the direction of the arrow;
2. If there is no arrow mark, the end face of the pin in the observation hole can be observed. If it is flat and has a tight gap, we call the end a temporarily and the other end is circular. We call B temporarily. We need to push the pin out in the direction from B to a.
Replace the method of removing the needle: rotate the handle of the stripper clockwise, then pry the ring at the tail off, and separate the handle by a seam, and then remove the broken needle.
Then install a new stripper pin, buckle the ring, and fix it!!!
